Part No. SCAZ042891 1.3.4
19
E&OE
Operating Instructions Scarab M6
DISCHARGING THE HOPPER (TIPPING)
Ensure that all personnel are clear of the door.
Ensure that the suction fan is turned OFF and that there is room for
the door to open fully.
1. With the machine correctly positioned in the discharge area.
Proceed as follows:
Before raising the hopper, ensure that the machine is on firm, level
ground and there are no overhead obstructions.
2. Vehicle Engine OFF. Handbrake ON. Machine in Neutral.
Multi-function lever OFF.
3. Auxiliary engine ON. Refer to Page 16.
The safety interlock button
must be pressed in conjunction with
the following buttons.
4. Open the rear door fully
.
5. Raise the hopper fully
.
6. With the load fully discharged, move the hopper prop lever as
illustrated to engage with the prop latching assembly. Lower the
hopper fully
.
Before closing the door, ensure that the door seal, and mating
faces on the hopper, are free from any foreign matter that might
damage the seal or adversely affect the sealing function.
The rear door will not close via the remote control unless the hopper
is in the fully down position as determined by the hopper down
sensor.
7. Close the rear door
making sure the locking mechanism has
fully engaged.
8. Move machine clear of discharge area.
The hopper prop must always be in the deployed position when
working beneath a raise hopper. Failure to do so could result in
serious injury.
Ensure the prop is completely
unlatched when the hopper is
in the raised position.
Never work under a partially
raised hopper of if the hopper
Pull lever as shown, until
the hopper prop is correctly
latched, before lowering the
hopper.
is latched
