Fayat Group SCARAB M25H, Operating And Basic Maintenance Instructions

Page: 49 / 74

Manual No. SCAZ043075 1.7.01 49 E&OE
M25H Road Sweeper Operating Instructions
Suction nozzle flap adjustment
The suction nozzle flaps should be in good condition, and
adjusted to the correct clearance from the road surface
(15 mm).
These flaps have slotted holes to allow up and down
adjustment after loosening the appropriate nuts, bolts
q
.
After you have adjusted tighten anything loosened.
For some operating conditions, it might be found that,
alternative clearances are preferred.
Brush adjustments
Brush contact with the road surface can be altered as follows:
Before proceeding ensure people and objects are clear
of the brush area.
1. With the vehicle stopped, handbrake on, and in sweep
mode, activate the desired brush(es) in the working
positions.
2. Switch off ignition and remove the key.
Do not attempt to alter the brush settings while the
brush is rotating.
3. Slacken nuts
w
at back of motor plate
e
this will allow
the brush unit to rotate slightly to the left or the right.
4. Slacken bolts
r
, on both sides, which will allow the brush
unit to tilt forward and back.
5. Adjust until the brush is at the correct contact with the
road surface.
6. Tighten any items slackened during adjustment.
7. Start the vehicle, stow all sweeping equipment activated
for adjustment.
1
2
3
4
15 mm
Brush Patterns
Motor Centre