Fayat Group BOMAG BW 226 BVC-5, Service Manual

Page: 25 / 51

Before start up, carry out all required visual inspections and func-
tion tests.
If the following tests reveal damages or other faults, the machine
must not be operated, until these deficiencies have been corrected.
Do not operate the machine with defective indicators and control
elements.
1.2.6.2 Starting the engine
The machine must only be started and operated from the driver’s
seat.
Before starting and moving the machine, make sure that there is
nobody in the danger zone.
To start, set all control levers to “neutral position”.
Do not use any starting aids like start pilot or ether.
The machine must not be operated with damaged, missing or non-
functional safety installations.
After starting check all display instruments.
Do not inhale exhaust fumes, because they contain toxic sub-
stances, which could cause damage to health, unconsciousness or
even death.
For operation in closed or partly closed rooms ensure adequate
ventilation.
1.2.6.3 Starting the engine with jump leads
Connect positive with positive and negative with negative (ground
cable) – always connect the ground strap last and disconnect it
first! A wrong connection will cause severe damage in the electric
system.
Do not start the engine by shorting the electric terminals on the
starter motor, because the machine may start to drive immediately.
1.2.7 Driving the machine; working operation
1.2.7.1 Persons in the danger area
Before taking up work, also after breaks, you should always con-
vince yourself that the danger zone is free of persons or obstruc-
tions, especially when driving in reverse.
Give warning signals, if necessary. Stop work immediately if per-
sons remain in the danger zone, despite the warning.
Do not step or stand in the articulation area of the machine when
the engine is running.
General – Concerning your safety
BW 226 BVC-5 / BW 226 DI-5 25