KIC551
K I C 5 5 1 U s e r M a n u a l
3
© 2 0 2 1 F a s t w e l V e r . 0 0 3
List of Figures
Figure 1-1:
KIC551-01 ....................................................................................................................................... 15
Figure 1-2:
Location of main components of KIC551, top view (as exemplified by KIC551-01) ......................... 16
Figure 1-3:
Front panel of KIC551-01 ................................................................................................................ 17
Figure 1-4:
Front panel of KIC551-02 ................................................................................................................ 17
Figure 1-5:
Overall dimensions of KIC551 ......................................................................................................... 18
Figure 1-6:
KIC551RC-01 .................................................................................................................................. 19
Figure 1-7:
Main components of KIC551RC front panel (as shown by KIC551RC-01) ...................................... 20
Figure 1-8:
Overall dimensions of KIC551RC .................................................................................................... 21
Figure 2-1:
Block diagram for KIC551/KIC551RC .............................................................................................. 23
Figure 2-2:
Diagram of the main units of KIC551/KIC551RC ............................................................................. 26
Figure 2-3:
Diargam for multiplexing configuration EEPROM of KIC551/KIC551RC ......................................... 29
Figure 2-4:
Location of H13 LED and power supply battery connector on KIC551/KIC551RC .......................... 30
Figure 2-5:
Front panel LEDs ............................................................................................................................ 31
Figure 2-6:
UP LED (GP LED) ........................................................................................................................... 34
Figure 2-7:
RJ45 Ethernet Connector ................................................................................................................ 36
Figure 3-1:
Location of the reference point on the heat removal plate of KIC551RC ......................................... 43
Figure 3-2:
SA1 and SA2 microswitches ........................................................................................................... 48
All information in this document is provided for reference only, with no warranty of its suitability for any specific purpose. This information has been thoroughly checked and
is believed to be entirely reliable and consistent with the product that it describes. However, Fastwel accepts no responsibility for inaccuracies, omissions or their
consequences, as well as liability arising from the use or application of any product or example described in this document.
Fastwel Co. Ltd. reserves the right to change, modify, and improve this document or the products described in it, at Fastwel's discretion without further notice. Software
described in this document is provided on an “as is” basis without warranty. Fastwel assumes no liability for consequential or incidental damages originated by the use of
this software.
This document contains information, which is property of Fastwel Co. Ltd. It is not allowed to reproduce it or transmit by any means, to translate the document or to convert
it to any electronic form in full or in parts without antecedent written approval of Fastwel Co. Ltd. or one of its officially authorized agents.
Fastwel and Fastwel logo are trademarks owned by Fastwel Co. Ltd., Moscow, Russian Federation. CompactPCI is a trademark of the PCI industrial Computers
Manufacturers Group. Ethernet is a registered trademark of Xerox Corporation. IEEE is a registered trademark of the Institute of Electrical and Electronics Engineers Inc.
Intel is a trademark of Intel Corporation. Pentium M and Celeron M are trademarks of Intel Corporation. Microsoft is a trademark of the Microsoft corporation. In addition,
this document may include names, company logos and trademarks, which are registered trademarks and, therefore, are property of their respective owners.
Fastwel welcomes suggestions, remarks and proposals regarding the form and the content of this Manual.
