Fast MT765 Challenger, Installation-Parts

Page: 12 / 31

INSTALLATION & PARTS
INSTALLATION Track Tank MT765 Challenger Page 12
Install Tanks
WARNING: Each tank weighs
approximately 1100 lbs. Use an
appropriate lifting device to
prevent injury.
1. Connect an appropriate lifting device
to the right-hand tank.
2. Raise the tank (1) and guide it into
position onto its support bracketry.
3. Align the tank receiver with the
underside support and install ten 3/4”
x 2” GR8 flange bolts (2) with flange
nuts and two 1/2” x 5-1/2” bolts,
washers, and nuts (3). Refer to
torque charts in this instruction set for
bolt torque values.
4. Repeat the procedure with the left-
hand tank (4).
5. Disconnect the lifting devices.
Install Straps and Nylon
Protector
1. Position the straps (1) into place and
insert its studs through the holes in
the tank supports. Install one each
3/8” x 1” G5 bolts and nuts (2) and
1/2” flange nut (3).
2. Repeat the procedure on the left-
hand side.