Fast 9553P, Owner'S Manual

Page: 44 / 87

CONTROLLER INSTALLATION
CONTROLLER INSTALLATION 3PT Sprayer 9553P / 9573P Page 44
CONTROLLER INSTALLATION
Each control box should be mounted in the
tractor cab.
Spray Circuit Controller
The control box is equipped with a "U"
bracket secured by knobs on each end of the
box. It provides a universal mounting system
adaptable to any configuration.
Use the two holes provided in the bracket to
mount the box to a solid surface. Position the
box to face the operator and tighten the
knobs to hold the box in position.
Cut the power cable to the required length.
Connect the white wire to ground and the red
wire to a 12-volt battery or power port. Refer
to Controller’s Manual. The panel fuse is an
AGC-15 amp.
IMPORTANT: Do not connect across a
24-volt system. It will damage internal
electrical components.
Boom Function Control Box
Mount the box next to the sprayer controller
to allow easy access. Connect to 12-volt
power port. The box’s fuse is an AGC-10
amp.
Plug the wiring harness from the trailer into
the plug on the pigtail that comes from the
Boom Function Control Box. Make sure to
properly index the connector.
Foam Marker Switch (Optional)
Mount the switch next to the Boom Function
Control Box to allow easy access for the
operator. Be sure to install the switch so that
moving to the left activates the left marker.
Connect the short wire to a 12-volt, 30-amp
power source. Secure with a strap, tape,
plastic ties, or a magnet.