2
Part #30161
Revised 8/14/07
FAST™
3400 Democrat Rd.
Memphis, TN 38118
Phone: (901) 260-3278 Fax: (901) 375-3408
www.fuelairspark.com
The following steps are typical of most installations
:
Section 1 – Fuel Pump Installation
Section 2 – Fuel Regulator Installation and Fuel Line Plumbing
Section 3 – Fuel Line Hose End Installation
Section 4 – Electrical Installation
Section 5 – Final Checks and System Start-up, Fuel Pump Template
Typical hose end to fitting connection:
Typical o-ring sealed port connection:
Do not
connect hose end to cutoff side of union!
Connect hose end to 37-degree flare side of union.
Hose End
O-ring sealed AN style port
O-ring (Install on union fitting between
back of threads and face of hex nut.)
Typically the cutoff side of the union is used as
the o-ring sealed side, leaving the 37-degree
flare side for your hose end connection. In
some cases both sides of the union utilize an o-
ring seal. For example, in this kit a union
connects the port of the fuel pump and filter.
