A.
Prepare FASS return line by cutting rubber junction connecting the
filler neck to the fuel tank.
C.
Using a HC-1001 connect FL-1002 Fuel Line to the junction of RM-
1004.
D.
Using a hose clamp install the fuel line over the knurled flare on the QD
-1001. Oil O-rings inside Quick Disconnect.
E.
Disconnect factory suction line clip by pressing in on the two tabs lo-
cated on either side in the connection fitting. Once removed, clean the
suction tube and connect the QD-1001 addressed in the previous step.
Loop fuel line over frame, will be addressed in step Installing Fuel
Line. Plug or seal factory line or remove.
B.
Filler neck removed for clarity. Insert & position, into cut filler neck,
RM-1004 with the junction pipe aiming to outside of bed. Clamp rub-
ber and RM-1004 using both HC-1004’s and factory clamps.
Step 2:
Prepare suction & Return lines
Some of the photo’s are of a different application, procedures are the same.
Helpful Hint: If more space is required to access the top of the fuel
tank, loosen the strap nuts to the end of the stud. This will gain you
about 3” more working room. Bed has been removed for picture-
clarity.
