Faro Focus 3D X 130, Training Manual, Page: 133 / 340

LL7
LMLLMM 4M T MMMMM AMMMMMMmMMML
Focus
3D
X 130 and X 330 • SCENE 5.3
September 2014
AMMMvMMy M.MM
Capturing Scans with Targets
In this activity, you will practice capturing scan data, including
planning scanner positions, arranging and mounting targets,
and creating the project structure. Complete the scans within
30 minutes. Use at least four targets.
Follow these steps:
1. Create a site sketch on the worksheet provided.
A. Add scanner positions to the site sketch.
B. Add target arrangements to the site sketch.
Be sure to plan scanner positions and target
arrangements so that the targets are not at the start/
stop point of the scanner.
2. Arrange and mount targets in the scan area.
3. Set the parameters for the first scan.
4. Turn the sensors on or off, as needed.
5. Make sure the correct subproject is selected so that the
capture scan data will have the correct name.
A. Tap MMMMMM > MMMMMMML .
B. Tap Training_[ Your Initials ].M so it is highlighted.
C. Tap HMmM .
6. Capture the first scan.
A. Using your site sketch, move the scanner to the first
scanner position.
B. If necessary, use the inclinometer to make sure the
scanner is level.
Slide 145