Farmi Forest W35R, Operation, Maintenance And Spare Parts Manual

Page: 31 / 42

W35R
31
TROUBLE SHOOTING
CONDITION POSSIBLE CAUSE REMEDY
Hard to pull the cable
out
Drum brake is too tight. Loosen the drum brake. See
instructionsfrom item ”Adjusting the
drum brake”.
Cable gets tangled on
the drum.
Cable too loose on the
drum. The cable is pressed
between loose loops.
Loosen the pin and pull the cable
from the reel with the help of a
tractor. Reel the cable tightly back in
with the help of the load.
Cable develops kinks. Cable brake too loose. Tighten the drum brake.Tighten cable
on the drum by pulling out the cable
and by winching with a heavy load.
Roller chain comes
off.
Roller chain too loose,
some part is broken or the
aligning is incorrect.
Check the aligment of the chain.
Check possible damages. Adjust the
roller chain, change if neces- sary. See
chapter ”Adjusting the roller chain”.
Rattling sound Roller chain too tight,
some part is broken or the
aligning is incorrect.
Check the aligment of the chain.
Check possible damages. Adjust the
roller chain, change if neces- sary. See
chapter ”Adjusting the roller chain”.
Insufficient pull on
the cable Normal wear of the clutch.
Minimum thickness of the
clutch plates is 7 mm.
See chapter ”Clutch adjustment”
Oil or grease in the clutch Disassemble and clean the parts.
Clutch too loosely adjusted Adjustment of the clutch. See chapter
”Clutch adjustment”
Tractor slides
backwards when
winching
Parking brakes are not on.
Dozer blade does not
anchor the
unit firmly to the ground. Lock on the parking brakes. Lower
the winch all way to the ground.