Farmet TRITON 600 PS, Operating Manual

Page: 37 / 40

37
│
40
Manual
TRITON 450 PS
|
600 PS
TRITON 450 PS
10 MACHINE MAINTENANCE AND REPAIR
Observe the safety instructions for treatment and maintenance.

If it is necessary to weld during the repair and have the machine connected to the tractor, it must have
disconnected supply cables from the alternator and the accumulator.

Check the tightening of all screw and other assembly connections at the machine before every use of
the machine, furthermore continuously as needed.

Continuously check the wear of the working bodies of the machine, possibly replace these worn
working bodies with new ones.

Adjustment, cleaning, and lubrication of the machine may only be performed with the machine at rest
(i.e. the machine is standing and not working).

When working on a lifted machine, use suitable support equipment supported at marked points or at
points suitable for that.

During adjustment, cleaning, maintenance, and repair of the machine, you must secure those parts of
the machine that could endanger the operator by falling or another movement.

For catching the machine during handling using lifting equipment, use only the places marked with
self-adhesive labels with the chain sign "
".

Upon a failure or damage of the machine, immediately turn off the tractor's engine and secure against
restarting, secure the machine against movement

only then you can remove the failure.

During repairs of the machine, use exclusively the genuine spare parts, suitable tools and protective
equipment.

Regularly check the prescribed pressure in the machine tyres and the condition of the tyres. Perform
possible repairs of the tyres in an expert workshop.

Check the indicator of loose nuts, “Check Point”, regularly according to the instructions.

Keep the machine clean.
Do not clean hydraulic cylinders and bearings with a high-pressure cleaner or direct water
stream. The seals and bearings are not watertight at high pressure.
11 MACHINE STORAGE
Long-term machine shutdown:

Store the machine under a roof if possible.

Store the machine on a flat and solid surface with sufficient load capacity.

Clean the machine before storing and conserve so that it is not damaged in any way during storage.

Store the machine in the position with folded frames in the transport position. Store the machine on
the axle and the storage leg, secure the machine against spontaneous movement using scotches or
another suitable tool.

When storing, lower the machine into the lower position using hydraulics.

The machine must not rest on the discs and the chisel units. There is a risk of damage to the working
discs or chisel breakage.

Secure the machine against access of unauthorised persons.