Farmet SOFTER 8 PS, Operating Manual

Page: 14 / 29

Manual
SOFTER 8 PS | SOFTER 11 PS
14
│
29
2. MACHINE ASSEMBLY AT THE CUSTOMER
 The operator must perform the assembly according to the instructions of the producer, best in cooperation
with the expert servicing technician determined by the producer.
 The operator must secure a functional test of all assembled parts after the completion of the machine
assembly.

The operator must secure that the handling of the machine using lifting equipment during its assembly is
in accordance with chapter
„C“
.
3. COMMISSIONING

Before taking over the machine, test and check, whether damage occurred during transport and whether
all parts contained in the bill of delivery were supplied.

Before commissioning the machine, carefully read this operating manual, especially Chapters A-D p. 4-9.
Before the first use of the machine, familiarise yourselves with its controls and overall function.
 During work with the machine, observe not only the instructions of this operating manual but also
generally valid regulations of work safety, health protection, fire and transport safety, and environmental
protection.
 The operator must check the machine before every use (commissioning) from the standpoint of
completeness, work safety, work hygiene, fire safety, transport safety, and environmental protection.
Stroj A machine showing signs of damage must not be commissioned.
 Aggregation of the machine with the tractor is to be performed on a flat and hardened surface.

When working on slopes, observe the lowest allowable slope grade of the set TRACTOR - MACHINE .
 Before starting the tractor motor, check whether no person or animal is in the working space of the set and
push the warning sound signal.
 The operator is responsible for the safety and all damage caused by the operation of the tractor and the
connected machine.

The operator is obliged to adhere to the technical and safety regulations of the machine determined by the
producer when working.

When turning the machine at headland, the Operator must lift the machine, i.e. the working bodies are not
in the ground
.
 The operator is obliged to observe the prescribed working depths and speeds stated in the manual in Tabl.
2 /p. 4 when
 The operator is obliged to lower the machine to the ground and secure the set against movement before
leaving the tractor cabin.
DECREASE OF SOIL PRESSURE TO A VALUE LOWER THAN 200 kPa (29 Psi)
- To decrease the specific pressure on soil (lower than 200kPa / 29 Psi) at the turns on the headland, raise the
machine on the pole by using the hydraulic tractor shoulders and rear rollers. Turn around when the machine
is unfolded and resting on rollers.