Farmet KOMPAKTOMAT K1000PS, Operating Manual

Page: 36 / 56

Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
36
│
56
Machine Number section (pc)
K500PS, K600PS, K700PS, K800PS 3
K1000PS 5

The basic version of height setting is mechanical using a handle …MCD

The height of the shares can be controlled from the tractor cabin using a hydraulic circuit as an above-
standard option …HD
o
The distribution of the hydraulic circuit includes elements providing even movement of all share
frames. Therefore, do not limit the oil flow on the control panel of the circuit. The flow rate values
should range between 75 and 100% capacity.
o
Without the manufacturer´s prior consent, do not interfere with the hydraulic circuit components in
any way!
7.4.1 MCD- MECHANICAL DEPTH SETTING

Standardly, the depth is set mechanically by turning the handle manually. Each working section of the
machine is controlled individually.

The depth setting is increased by turning the handle anticlockwise – red arrows in the picture.

The depth setting is decreased by turning the handle clockwise – white arrows in the picture.

There is an indicator near the handle that shows that all the sections are set at the same depth.
7.4.2 HD- HYDRAULIC DEPTH SETTING

The depth is set from the tractor driver’s position. All working sections are controlled at the same time.

The depth setting increases when the piston-rods are drawn out – red arrows in the picture.

The depth setting decreases when the piston-rods are drawn in – white arrows in the picture.

There are indicators located in spots visible from the tractor that show that all the sections are set at the
same depth.