Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
33
│
56
Setting the depth of the cultivator is performed by removing the pin and moving the cultivator in the
holder. Before setting the depth of the cultivators, set the machine in the position when the cultivators
are not loaded.
The machines are standardly equipped with 2+2 cultivators = CA4 / CC4. A larger number can be used
above standard, however, the maximum number is 4+4 = CA8 / CC8.
7.2
ADJUSTING THE SPRING-MOUNTED FRONT LEVELLER
Correct position of the front leveller affects the resulting quality of processing.
When adjusting the position of the levellers, always observe generally valid labour safety regulations.
Perform the adjustment of front levellers when the machine is unfolded in the working position and
standing on the working sections at the same time.
The front leveller is a very important part of the machine. It contributes largely to the levelling ability of
the Kompaktomat machines. Therefore, it is important to adjust it properly.
As for the fixed serrated leveller, it is possible to adjust the height and the preloading of the draw spring.
As for the blade leveller, it is possible to adjust the height and the angle of the blades.
The basic version of the height adjustment is mechanical.
It is possible to control the height of the leveller from the tractor cabin using a hydraulic circuit as an
above-standard option.
o
The distribution of the hydraulic circuit includes elements providing even movement of all levelling
bars. Therefore, do not limit the oil flow on the control panel of the circuit. The flow rate values should
range between 75 and 100% capacity.
o
Without the manufacturer´s prior consent, do not interfere with the hydraulic circuit components in
any way!
FRONT LEVELLER VERSIONS (p. 16)
FL-FIXED SERRATED
L-BLADE
Min.535mm
Max.700mm
