Manual
FALCON SW
65
│
80
14.1.
REPLACEMENT OF WORN DISCS
When replacing discs, always observe safety regulations and directives.
The machine must be aggregated with the tractor according to Chapter “3.1/P.13” for the replacement of
the discs. The tractor engine must be switched off and the operator or the mechanic must prevent
unauthorized access to the tractor.
The machine must be lifted on the transport axle and in the arms of the tractor for the replacement of the
discs.
Raise the rear tractor TPS shoulders with the aggregated machine to the maximal position and secure it
from falling. Then you may perform the replacement of worn shares.
The ball valve of the axle must be in the “closed” position, see Picture 30/P.39. You must ensure mechanical
supports under the pole of the machine in case the tractor hydraulic system is not tight.
Only replace the discs on a firm and flat ground and when the machine is in standstill.
14.2.
THE PRESSURE IN THE TYRES
Tab. 10
LUBRICATION POSITION
INTERVAL
LUBRICANT
Pole joint
Picture 51
1 x week *
Plastic lubricant K EP2 - 30
DIN 51 502
Bearings of axle
Picture 52
1 x year *
*- Applies to the period when the machine is used on the field
.
Picture 51 – Pole joint
Picture 52 – Bearing of axle