Farmet FALCON 3, Operating Manual

Page: 5 / 99

Manual
FALCON 3 | 4 | 6 | 8
5
│
99
1 QUICK START
0
Safety warning
9
1
Pull the Falcon with the pulling device
18
2
Connect the return hydraulic hose
24
3
Connect the other hydraulic hoses
19
4
Connect the 7-pin cable for the road lights of the machine
5
Connect the machine electronics with the pulling vehicle.
21
6
Lift the front supporting leg of the machine and secure it
7
Release the pins for unfolding the front section
46
8
Open the valve for unfolding (blue marking)
46
9
Open the valve for lifting the front preparatory section (yellow marking)
50
10 Use the main switch
to switch on the seed drill terminal
11 Unfold the machine using the hydraulic circuit and the control terminal
46
12 Set the pressure using the pressure reducing valve
68
13 Check the seed cleanliness
88
14 Check for leakage of the planer in the seedbed
88
15 Check the flow of the fertilizer hoses
16 Check the seed hose for continuity
17 Pour the seed
50
18 Pour the fertilizer
50
19 Check and adjust the seeder plane
65
20 Set the lower end of the tractor's TPS
65
21 Set the sowing depth
66
22 Adjust the depth of the front section
70
23 Set the dose in the electronics
58
24 Set the value on the doser
52
25 Perform a test shot
59
26 Enter the value of the weighed sample into the terminal
59
27 Check that the seeding speed range displayed on the terminal is optimal: 1.5-20 km/h
59
28 Set sensor sensitivity according to the table in the manual
41
29 Set the priority on the fan's hydraulic circuit
30 Adjust the oil flow for the fertilizer hydromotor
19
31 Set the fan speed, by seed and batch
63
32 Set the required hydraulic functions - indicators, track markers, etc.
30
33 Set the required pressure on the seedbed, depending on the soil conditions (20-60bar).
68