Farmet FALCON 3, Operating Manual

Page: 18 / 99

Manual
FALCON 3 | 4 | 6 | 8
18
│
99
6.1. AGGREGATION TO THE TRACTOR
 The machine may only be connected to a tractor whose standby weight equals or is higher than the total
weight of the attached machine.
 The operator must observe all generally valid regulations for the safety at work, protection of health, fire
safety and protection of environment.

The operator may only attach the machine to a tractor which is equipped with a rear three-point
suspension (TPS) and a functional undamaged hydraulic system.
 The table with the requirements for the tractive instrument for work with the machine:
Tab.3
(5)
Requirement for the engine power of the tractor for
FALCON 3
90 kW*
(5)
Requirement for the engine power of the tractor for
FALCON 4
117 kW*
(5)
Requirement for the engine power of the tractor for
FALCON 6
161 kW*
(5)
Requirement for the engine power of the tractor for
FALCON 8
205 kW*
(6)
Requirement for TPS of the tractor
(7)
distance of the bottom suspension
hinges (at the axes of the hinges) 1010±1,5 mm,
(can be also set to 910±1,5 mm)
(8)

holes of the bottom suspension
joints for the suspension hinge pins of
the machine

37,5 mm
(9)
Requirement for the hydraulic system
of the tractor
(x)
circuit of the electric distributor
(14)
Pressure in the circuit
min.190 bar – max.230
60 l/min., 2 sockets for snap
coupling ISO 12.5
(19)
circuit of the hydraulic engine
(20)
Pressure in the filling branch
min.130 bar–max.230 bar, 1
socket for snap coupling ISO
12.5
(21)
Pressure in the waste branch
max.3 bar, 1 socket for snap
coupling ISO 20
(x)
down-pressure of the sowing bodies
(14)
Pressure in the circuit
min.190 bar – max.230
10 l/min., 1 sockets for snap
coupling ISO 12.5
(x)
circuit of lifting and lowering the
preparatory section
(14)
Pressure in the circuit
min.190 bar – max.230
40 l/min., 2 sockets for snap
coupling ISO 12.5
(12)
Requirement for the air system of the
tractor (if the machine is equipped with
brakes)
(13)
circuit of braking of the machine
axle
(16)
Pressure in the circuit min.6
bar – max. 15 bar, 1 clutch head
for single circuit brakes
(x)
Requirement for the electric system of
the tractor *
(x)
connection of the electronic system
of the machine
12V / 40 A
+ red - black
 Connect the machine with the carrier bar TPS to the lower arm of the tractor TPS and secure the TPS arms
with pegs against disconnection.
When connecting the machine, there must not be any people in the area between the machine
and the tractor
.