Manual
EXCELENT Premium 6; 8
43
│
52
Plane
7.3.
CALIBRATION THE MACHINE PLANE
The basic machine plane is preset by the producer.
Check this plane regularly once during the season, after you replace all the shares.
The check must be performed on a flat and solid surface with bumps up to 1 cm.
Plane calibration:
1. Place the machine on a flat and solid surface
2. Unfold the machine into the working position
3. Lift the front levellers and harrowing to the highest position so that they do not touch
the pad when placed on the pad
4. Set the depth setting plates to “
0
”
5. Lower the machine to the ground so that shares are sitting on the ground
6. Turn the screw for the machine springing (clockwise) so that a gap is created between
the stop board and the stop position of the pneumatic roll frame
7. Then turn the screw for the machine springing (anti-clockwise) so that the stop board
is leaning against the stop of the pneumatic roll and stop turning at the moment when the
shares start to lift from the pad.
8. Set all 13 pieces of springing in the machine in the this way
Picture 63 – Plane of the machine
Picture 64 – Setting the plane of the machine
Stop board
„ 0 “
Plate
Roll frame stop
Springing screw
Gap 2 mm
Gap 0 mm
