MACHINE MAINTENANCE AND REPAIRS
11.2 Replacement of the working roller bearings
• Always follow the safety regulations and directives when replacing the bearings of rollers.
• The machine must be aggregated with the tractor according to Chapter “8.1” when replacing the
bearings. The tractor engine must be switched off for the replacement of bearings and the operator, or
repairman, must prevent any access to unauthorised persons to the tractor
• Only replace the roller bearings on a solid and flat ground and when the machine is in standstill.
1 – Roller bearing
1 – Bolt
2 – Spacers
3 – Pin cylinder
øD – 40 mm – Bolt M10 (50 Nm) / M8 (20 Nm)
øD – 45 mm – Bolt M12 (86 Nm) / M10 (20 Nm)
øD – 50 mm – Bolt M12 (86 Nm) / M10 (20 Nm)
øD – 60 mm – Bolt M12 (86 Nm) / M10 (20 Nm)
27
|
38
Summary of Contents for DISKOMAT 3 N
Page 2: ...2 38 Prepared by Technical Department Farmet a s on 31 08 2023 changes reserved...
Page 4: ...PREFACE 4 38 IMPORTANT READ CAREFULLY BEFORE USE KEEP FOR FUTURE REFERENCE...
Page 6: ...PREFACE 6 38...
Page 15: ...WORK SAFETY LABELS Fig 1 Location of safety labels on the machine 15 38...
