8.1 Agregation to a tractor
•
The machine may only be connected to a tractor with a service weight and parameters
allowing for safe work with the attached machine and its safe transportation on roads.
•
The machine operator must observe all generally valid regulations of work safety, health
protection, fire safety, and environmental protection.
•
The operator may connect the machine exclusively to a tractor that is equipped with a rear
three-point suspension and a functional undamaged hydraulic system.
•
The table of requirements for the towing means for work with the machine:
Requirement for the tractor
engine power for disc plough-
harrow
DISKOMAT 3 N
105 – 158 kW (140 – 215 HP)
DISKOMAT 3,5 N
120 – 180 kW (160 – 240 HP)
Requirement for the tractor's TPS
Spacing of the lower suspension
joints (measured at the joint
axes)
1050±1,5 mm (41,34 in)
Øof the hole of the lower
suspension joints for the
machine suspension pivots
37,5 mm (1,48 in)
•
Connect the machine using the TPS suspension to the lower arms of the rear TPS of the
tractor, secure the TPS arms using pins against disconnecting.
•
The machine aggregated with the tractor changes the distribution of the weight to the
individual axles of the tractor. The weight of the front axle is reduced and therefore the
controllability gets worse. It also affects braking properties.
When connecting, no persons may stay in the space between the tractor and the machine.
19
|
38
Summary of Contents for DISKOMAT 3 N
Page 2: ...2 38 Prepared by Technical Department Farmet a s on 31 08 2023 changes reserved...
Page 4: ...PREFACE 4 38 IMPORTANT READ CAREFULLY BEFORE USE KEEP FOR FUTURE REFERENCE...
Page 6: ...PREFACE 6 38...
Page 15: ...WORK SAFETY LABELS Fig 1 Location of safety labels on the machine 15 38...
