Farm King 2400, Operator And Parts Manual, Page: 43 / 112

Operation - Round Bale Carrier 2400
43
Loading Procedure
Move to the operator’s position, start the engine and
release the parking brake. (See “Entering The Operator’s
Position” on page 37.)
Move the tractor and bale carrier straight forward up to 5
mph (8 km/h), center the first bale in the bale forks.
Empty / Full Indicator
Figure 35
Indicator Down - Available deck space for additional
bales or all bales have been removed (unloaded) from
deck.
Indicator Up - When the bale carrier reaches its
capacity, bales will contact and move the rear indicator
backward, pulling the cable raising the front indicator
plate (upright) indicates not to load any more bales.
Before operating the equipment:
• Clear the work area of all bystanders, especially
small children.
• Clear the work area of all obstacles.
• Keep shields and all guards in place.
• Keep away from moving parts.
To avoid unbalanced loads, only push front bales
back one bale length to prepare for the next bale.
When loading bales, maintain a minimum of 2 ft. (61
cm) between rear bales and rear of carrier deck.
Rear bales must not extend beyond the carrier deck.
B-10056
CARRIER DECK EMPTY CARRIER DECK FULL
At the end of the unloading process, front indicator
comes down (after pushing off the last bales)
warning the operator to release pusher back button,
then move forward, lower beam and bring the
pusher home (fully forward).