Fanvil X3SP, User Manual

Page: 72 / 90

<
文档标题
>
Default Ring Type Set the default ring type. If the caller ID of an
incoming call was not configured with specific
ring type, the default ring will be used.
Handset Volume Set the Handset volume, the value must be 1~9
Headset Volume Set the Headset volume, the value must be 1~9
Headset Ring Volume Set the ring volume in the headset, the value
must be 0~9
Speakerphone Volume Set the speakerphone volume, the value must
be 1~9
Speakerphone Ring Volume Set the ring volume in the speakerphone, the
value must be 0~9
Headset Volume Offset This is to adjust the base volume of the headset.
Please note when set the volume at the
maximum level it may create noise and
decrease the echo canceller.
Headset Mic Offset This is to adjust the base volume of the headset
Mic.
G.729AB Payload Length Set G729 Payload Length.
G.723.1 Bit Rate 5.3kb/s or 6.3kb/s is available
G.722 Timestamps 160/20ms or 320/20ms is available
DTMF Payload Type Enter the DTMF payload type, the value must be
96~127.
Enable VAD Enable Voice Activity Detection. When enabled,
the device will suppress the audio transmission
with artificial comfort noise signal to save the
bandwidth.
Enable MWI Tone The phone will play MWI tone when a new MWI
Comes
8.18 PHONE / MCAST
This feature allows user to make some kind of broadcast call to people who are in multicast group.
User can configure a multicast DSS Key on the phone, which allows user to send a Real Time
Transport Protocol (RTP) stream to the pre-configured multicast address(es) without involving SIP