15
Figure 1 - Picture 13 - MCAST
Table 5 - MCAST
Parameters
Description
Enable Auto Mcast
Send the multicast configuration information by Sip Notify signaling,
and the device will configure the information to the system for
multicast listening or cancel the multicast listening in the system after
receiving the information
Auto Mcast Timeout Delete
Time
When a multicast call does not end normally, but for some reason the
device can no longer receive a multicast RTP packet, this
configuration cancels the listening after a specified time
SIP Priority
Defines the priority in the current call, with 1 being the highest priority
and 10 the lowest.
Intercom Priority
Compared with multicast and SIP priority, high priority is pluggable
and low priority is rejected
Enable Page Priority
Regardless of which of the two multicast groups is called in first, the
device will receive the higher priority multicast first.
Enable Mcast Tone
When enabled, play the prompt sound when receiving multicast
Name
Listened multicast server name
Host:port
Listened multicast server’s multicast IP address and port.
Multicast
：
⚫
Go to web page of [
Function Key
] >> [
Function Key
], select the type to multicast, set the
multicast address, and select the codec.
⚫
Click Apply.
⚫
Set up the name, host and port of the receiving multicast on the web page of [
Intercom
Settings
] >> [
MCAST
].
⚫
Press the DSSKey of Multicast Key which you set.
⚫
Receive end will receive multicast call and play multicast automatically.