Fantasea FP7000 Housing Instruction Manual 20110201
16
7.
If inserting a silica gel pack inside the housing in order to
prevent moisture, it is best to insert it on the left side of
the camera (image #9), where it doesn’t interfere with
proper housing operation. It is important to make sure
that the silica gel pack doesn’t stick out, or else it might
interfere with the watertight seal of the housing.
CLOSING THE HOUSING
1.
Turn the latch dial so that the small red tab located on the latch is pointed towards the front side
of the housing (image #10).
2.
Carefully close the back door of the housing, pushing it against the front door.
3.
Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #11).
4.
Gently try pulling the back door away from the front door. If the housing is properly closed, it
should be impossible to open the back door.
5.
Visually inspect the O-ring for proper closure. Make sure it isn’t twisted or out of the groove and
that no foreign matter has been caught in the seal.
6.
Turn on the camera and check that the extended camera lens does not catch or bend the black
rubber seat on the inside of the lens port. It is vital that the lens does not disturb this rubber
seat.
7.
Test housing control buttons to make sure that the camera was properly installed inside the
housing and that nothing interferes with normal operation of the camera. It is recommended to
Image #9
Image #10
Image #11
