Fanstel BluNor BT40F, Manual

Page: 1 / 31

BLE 5.1 Modules, BT40/F/E
Ver 0.90 March 2021
1
BluNor BT40F is a powerful, highly flexible, ultra low power Bluetooth Low Energy (BLE) using
Nordic nRF5340 SoC. With a dual core ARM
Cortex
TM
M33 MCU, embedded 2.4GHz multi-
protocol transceiver, and an integrated PCB trace antenna or u.FL connector for an external
antenna. It allows faster time to market with reduced development cost.
No external component needed to minimize host PCB area: Both 32 MHz and 32.768 KHz, -40
o
C to +105
o
C,
20 PPM crystals are integrated. DCDC inductors for VDD and VDDH are integrated.
Specifications:
nRF5340 QKAA, dual core ARM
®
Cortex M33
Application Core
•
128/64 MHz Cortex M33 with FPU and DSP
instructions
•
1MB flash, 512KB RAM
•
8KB 2-way set associate cache
•
ARM® TrustZone® Cryptocell-312 co-processor
Network core:
•
64 MHz Cortex M33 with 2KB instruction cache
•
256KB flash, 64KB RAM
•
2.6 mA in RX and 3.2 mA in 0dBm TX
•
Receiver Sensitivity: -97.5 dBm at 1Mbps
•
TX power: progra3dBm to -20dBm
•
BLE 5.1 data rate: 2Mbps, 1Mbps, 500kbps, 125kbps.
•
EEE 802.15.4 data rate: 250 Kbps
•
2.4 GHz proprietary data rate: 2 Mbps, 1 Mbps
DC-DC converter, inductors for VDD, VDDH on
board.
Direct powered by Lithium batteries or USB supply (up
to 5.5V)
Serial Wire Debug (SWD)
Nordic SoftDevice Ready
Over-the-Air (OTA) firmware update
48 General purpose I/O pins
USB 2.0 full speed (12 Mbps) controller
QSPI interface
Type 2 NFC-A tag with wake-on field, Touch-to-pair
support
Programmable peripheral interconnect (PPI)
12 bit/200 Ksps ADC, 8 configurable channels with
programmable gain
Temperature sensor
Up to 3x pulse width modulator (PWM)
Audio peripherals: I
2
S, digital microphone interface
(PDM)
5 x 32 bit timers with counter mode
Up to 3x SPI masters/3x SPI slaves
Up to 2x I
2
C compatible 2-wire masters/slaves
2x UART (CTS/RTS)
Quadrature Demodulator (QDEC)
2x real time counters (RTC)
Hybrid pins: 16 castellated and 45 LGA.
Both 32 MHz and 32.768KHz crystal on board
Integrated PCB trace antenna or u.FL connector
Operation voltage: 1.7V to 5.5V
Q D I D :
Model Summaries
module BT40F BT40 BT40E
SoC nRF5340 QKAA nRF5340 QKAA nRF5340 QKAA
Size 15x20.8x1.9mm 14x16x1.9mm 14x16x1.9mm
32 MHz and 32.768 kHz crystals Integrated Integrated Integrated
DC converter inductors, VDD,VDDH Integrated Integrated Integrated
BT Antenna
PCB ANT
0.88dBi
PCB ANT -3.37dBi
Dipole ANT 6dBi
Max TX
Operating temp. -40
o
C to +105
o
C -40
o
C to +105
o
C -40
o
C to +105
o
C
Availability Sample Sample 1Q21 Sample