FANOX SIL-V, User Manual, Page: 97 / 212

www.fanox.com Rev.10 97/212
7.6. Menus
7.6.1. Standby mode screen
The default screen shows the device model and the voltages in phase A, phase B, phase C,
and residual or busbar voltage (depending on model)
. Press “OK” to select a menu:
measurements, states, settings, and events. If the HMI is left in any state, it will return to the
default screen after 5 minutes without any key being pressed.
SILV000C0A12BA
0.00 0.00 0.00 0.00
C
(A) (B) (C) (R)
0.00 0.00 0.00 0.00
C
SILV000C0A12BA
0.00 0.00 0.00 0.00
If any error is detected by the self-diagnosis, an error message appears in the second line
(instead of the voltages) on the main screen, which can show any of the following information:
(see inside self-diagnosis section).
•
PROTECTION ERROR
•
MEASUREMENT ERROR
•
EEPROM ERROR
•
EVENT ERROR
7.6.2. Last Trip screen
When a trip occurs, the default screen alternates with the last trip screen, showing the cause of
the trip and the time and date of its occurrence.
The last trip screen will disappear when the
“RESET” button is pressed and hold down.
Trip 59-1
07/04/15 13:51:44825