FANOX SIL-D00, User Manual, Page: 101 / 226

www.fanox.com Rev.06 101/226
7.6. Menus
7.6.1. Standby mode screen
The default screen shows the device model and the currents in phase A, phase B, phase C, and
Neutral. Press “OK” to select a menu: measurements, states, settings, and events. If the HMI is
left in any state, it will return to the default screen after 5 minutes without any key being
pressed.
SIL-D000C1A12AA
0.00 0.00 0.00 0.00
C
(A) (B) (C) (N)
0.00 0.00 0.00 0.00
C
SIL-D000C1A12AA
0.00 0.00 0.00 0.00
If any error is detected by the self-diagnosis, an error message appears in the second line
(instead of the currents) on the main screen, which can show any of the following information:
(see inside self-diagnosis section).
•
PROTECTION ERROR
•
MEASUREMENT ERROR
•
EEPROM ERROR
•
EVENT ERROR
7.6.2. Last Trip screen
When a trip occurs, the default screen alternates with the last trip screen, showing the cause of
the trip and the time and date of its occurrence.
Even is auxiliary power is lost, when the SIL-B regains power, it will retain information on the
last trip. The last trip screen will only disappear when the “RESET” button is pressed and held
down.
Trip 67N1
07/01/15 13:51:44825