ISO 9001:2008
www.fanox.com
SIAC116B1011AB_Rev. 05
6 / 32
1.4.
Relay installation
To fix the relay to the switchgear, use default holes in front of relay with appropriate fixing
system. Do not manipulate relay to fix it on the switchgear.
How to change the internal battery
1. Disconnect the relay. Switch the power supply off to avoid any dangerous situation.
2.
Unscrew the 4 screws on the front of the relay to extract it from the RMU and access to
the rear side of the relay.
3.
Unscrew the 2 screws to remove the cover from the battery compartment.
4.
Remove the battery and replace it respecting polarity (+ facing up):
Battery characteristics:
o
AA 3.6V lithium battery
o
Model LS14500 from SAFT
o
Do not use rechargeable batteries or other types of battery
5. Put on the battery cover and tighten the 2 screws.
6. Put the relay into the RMU again and tighten the 4 screws on the front to fix the relay.
Warning:
HAZARD OF EXPLOSION
•
Do not recharge the battery.
•
Do not short circuit the battery.
•
Do not crush the battery.
•
Do not disassemble the battery.
•
Do not heat the battery above 100ºC (212ºF)
•
Do not throw the battery into fire or water.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
