Rev. 06
72/99
▲▼
Trip:
not activated
C
8.6.12. Settings Menu
From the standby mode screen, press the “OK” key to access the first line of menus. Use the “▲” and “▼” keys to position the cursor over the “SETTINGS”
screen and press “OK”. This takes you to the setting groups’ line. Use the “▲” and “▼” keys to position the cursor over a settings group, and press the “OK”
key to access the settings that belong to this group. Use the “▲” and “▼” keys to move through the different settings. The information that appears
underneath the setting name is its value.
Press the “◄” key to access the general settings from the "SETTINGS" screen.
The general setting "Equipment name" can be viewed from the HMI, but it can only be modified by using the SICom program.
The value of the "Nominal Current
” is the value, within the CT range, that is chosen as rated current and “CT type” is the type of the selected transformer.
It is necessary to enter a password to change a setting for the first time. The settings can be changed after entering the password, until returning either
manually or automatically to the standby mode screen. The system returns automatically to the standby mode screen if no key is pressed for five minutes.
The factory setting password for the equipment is 5555. This password can be changed using the SICom program.
The keys ▲, ▼, ◄ and ► are used to enter the password. The keys ▲ and ▼ are used to introduce a value or a character, and the ◄ and ► ones are used
to move from one character to another. If it is necessary to change one of the password characters or numbers due to an error, press "
C
" to delete it. Press
"
OK
” to validate the password.
The method for navigating through the settings menu and the sequence to follow to change a setting are shown graphically below:
Summary of Contents for SIA B
