Fanotec MECHA C1, User Manual

Page: 100 / 122

100
MECHA User’s Guide v.06 ‒ Dual Axis
© 2021 FANOTEC
Pairing PIN for more than 2 MECHAs
This section should be read after you read DAC test using the UI , where we
explain how to access the user interface.
The Pairing PIN is an extra option you can use when the pairing method is
zLM or zLM 2 to pair automatically at start more than 2 MECHAs connected
to the same network or to the same hot-spot.
To set a pairing PIN number:
● Access the MECHA-H web interface, as shown in the chapter DAC test
using the UI , and go to /config page.
● Create a four-digit number - the pairing PIN - and enter this number in
the field Pairing PIN .
● Then click the [Apply] button at the bottom of the page.
All MECHA units that have the same PIN will be paired together.
All pairing methods and requirements presented in this guide are still valid.
Once paired, if the PIN number is changed on MECHA-H, it will be
automatically set the same on MECHA-V.
If you want to break the pairing, please set a different PIN on MECHA-V.
Temporary Pairing
This type of pairing, or team, only lasts until the MECHA units are powered
off. To temporary pair two MECHA units:
● Power on both MECHAs.
● Start team building entering the code 1212< on horizontal MECHA. In
other words, the unit on which you enter this code, will rotate
horizontally.
● Confirm the participation in the team, entering the code 12< on vertical
MECHA. This unit will rotate vertically.