MECHA IR Remote Commander and Receiver
v.01
7
© 2021 FANOTEC
Menu Button
●
=
With C2 Controller, use this button to show the C2’s menus on the
display and also to switch from a menu to another.
Directional Buttons
●
<>
Use the left and right buttons to rotate the system manually to
the left and to the right, respectively, and also to specify the direction
when launching a preset using the IR Commander’s buttons, as
terminator for codes (similar to the Enter key).
●
/\
The up and down buttons control the up and down movement of
the upper rotator, when two rotators are used.
Trigger Button
●
S
The button located in the middle of the arrow buttons has a camera
trigger or confirmation function. During a pause, pressing
S
on IR
Remote, or
[SHOOT]
on UI, MECHA will trigger the number of shots
specified by
[TRG]
in presets. This can be used for extra shots for a
particular position.
Pause Button
●
:
Pause button is the equivalent of
[Pause]
UI button.
If MECHA is in
Pause
mode and a preset is started, MECHA will pause
before every position, resulting in step by step movement.
When MECHA runs a preset and is paused, you can press
>
, or
:
on
IR Remote, or
[PAUSE/NEXT]
on UI, to continue to the next position.
If, instead,
<
is pressed on C2 or on IR Remote, MECHA will continue to
the next position and switches on/off the step by step mode.
Numerical Buttons
●
1
Use it to enter the number 1. Use
[Save 1]
button in UI to save a
preset and assign it to this button.
