INSTRUCTION MANUAL
16” STAND FAN
MODEL: FLS-40
Technical data
Model
Voltage (V)
Frequency (Hz)
Input power (W)
FLW-40
230 V
50 Hz
40 W
Parts description
1. Fan housing
2. Fan blades
3. On/off and speed adjustment switch
4. Height adjustment stand
5. Stand
6. Protective cover
Before use for the first time
Assembly stand
Remove all the packaging.
Lay the two feet across each other and with them using the four screws.
Remove the height adjustment stand (4).
Slide the protective cover (6) onto the stand.
Put the height adjustment stand (4) back.
Assembly fan
Put the rear fan housing on the motor-housing, please check the alignment.
Slide the locking ring on the engine shaft, screw it tight (clockwise).
Slide the fan blades on the engine shaft, please check the alignment.
Fit the spinner on the engine shaft en tighten it, hold down the fan blades while turning (anticlockwise).
Fit the front fan housing on the back fan housing, using the clamps, screw and nut.
Loosen the lock on the back of the engine housing, put the fan on the stand and tighten the lock.
Use
Place the device on a flat, stable and dry surface (indoor use only) and put the plug into the outlet.
Adjust the stand to the desired height (4).
Select the desired angle or oscillate, from the left to the right with the button on top of the engine cover.
Select the desired speed of the fan with the on/off and speed adjustment switch (3)
Never insert fingers of any other object in the device when it’s connected to the outlet.
