Fancom LM.60i, Manual

Page: 11 / 39

LM.60i 4. Mounting
A5911664 - GB 100503 7
4. Mounting and Installation
4.1. Introduction
When mounting/installing the module, pay attention to the following points:
•
Mount the actuator where the weather can have no direct influence; not
in direct sunlight, or in places where the temperature can rise to
extremes etc.
•
Mount the actuator module in a place where the manual operation is
easy to access.
•
If the actuator is mounted within reach of people or animals (lower than
2.5 m above the floor) , a CE-protection cover must be mounted over
the shaft
(article number A5459007) .
•
It is advisable to seal all swivels after the actuator module has been
connected. This will prevent the entry of moisture, dust and/or
aggressive gasses.
•
Preferably do not mount the LM.60 with the drive shaft upwards,
otherwise water may enter the motor via the drive shaft.
If mounting the actuator with the shaft pointing upwards is unavoidable,
place a CE-protection cover over the shaft.
(article number A5459007) .
this will offer extra protection against the ingress of water