4. Hang the fan
4.1. Secure the hanger bracket to the ceiling joist or suitable piece of timber inserted between the
ceiling joists. The Hanger bracket should be secured using the screws provided.
4.2. Note - Fan and hanger bracket must be earthed during installation.
4.3. Carefully lift motor assembly (with blades) onto hanger bracket. Rotate fan until notch on down-
rod ball engages the ridge on the hanger bracket. This will allow hands free wiring.
5. Connect the Remote or Wall Control Receiver
5.1. Connect the Motor wire couplings to the correct positions in the receiver.
5.2. Connect the Grounding Wire (Electricity Supply wire) to correct position in the receiver.
5.2.1. Please see wiring diagram below
5.3. Fit the receiver in the gap in the Hanger Bracket
5.4. Fit the canopy cover to the Hanger bracket, by inserting the screws where the large part of the
holes are and slide over to lock. Note: When installing the canopy be careful not to press down the
antenna or other wires as these may break easily or short-circuit
5.5. Tighten screws.
4.1
5.1
5.2.1
4.3
5.4
INSTALLATION STEPS
AC IN
Antenna wire
Black wire
Summary of Contents for CFFCHZ4WHW
Page 16: ...WWW FANCO COM AU...
