Fanaway EVO1 LED Installation Instructions
5 |
P a g e
INSTALLING THE FAN
INSTALLING THE DOWN ROD
1. Remove the ball joint and dowel pin from the down rod (5) by loosening the set screw (3).
Do not discard keep these parts, they are required to reassemble later.
2. Feed the wires (2) and plug (1) through the down rod (5).
3. Insert the down rod into the
down rod housing
(7). Align the
down rod housing
hole with the down rod
hole.
Insert the pin (8) into the hole and secure with the pin spring lock (9).
4. Secure the down rod (5) and
down rod housing
(7) by tightening the two set screws (10) on the
down
rod housing
(7).
5. Install the
down rod housing cover
(6) over the
down rod housing
(7).
6. Slide the canopy (4) over the down rod (5).
7. Install the ball joint and dowel pin back onto the down rod (5) and secure by tightening the set screw
(3).
HANGING THE FAN
Lift the fan assembly onto the mounting bracket. Ensure the key slot (A) of the hanger ball is positioned
on the key pin (B) of the mounting bracket (C) to prevent the fan from rotating when in operation. (Fig.5)
Insert the LED driver into the lower section of the mounting bracket then insert the remote receiver into
the top section of the mounting bracket. Fig.6
Fig. 4
Fig. 5
Fig. 6
