Fanaway Classic Installation Instructions
10
|
P a g e
L D - 0 0 0 3 - 1 6 / X X X / 0 1
INSTALLING THE REMOTE BATTERY
2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery cover from
the back of the remote and insert 2 x AAA batteries. Ensure the polarities are correct as shown in the
battery compartment. (Batteries included.)
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and get
familiar with the buttons and function of each button.
LED Indicator
The red LED indicator on the top of the transmitter will flash when the buttons are active.
BUTTONS ON THE REMOTE
HI:
Press the button to set fan running at High speed.
MED:
Press the button to set fan running at Medium speed.
LOW:
Press the button to set fan running at Low speed.
OFF:
Press the button to turn OFF the fan.
LIGHT CONTROL BUTTON:
Press the button to turn the light ON/OFF.
Press and hold the button to access the light dimming function.
D / ON SWITCH
：
This
switch marked
D/ON
controls the dimming function of the lights. If using
non-dimmable bulbs, use a ballpoint pen or small screwdriver to set the
switch to
“D”
to disable the dimming function. If using dimmable halogen
bulbs, set the switch to
“ON”
to enable the dimming function.
Fig. 16
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorise
and recover the last status when turned on next.
Fig. 15
Fig. 16
