background image

 

ENGLISH 

Important safety instructions! Please read before connection! 

 

 

DANGER! (Electric shock due to high voltages in the device) 

The housing must not be removed! There are 

no

 parts to be maintained in the device. 

Inside the unit there are components which are under high electrical voltage. 

 
Before each use, check the device for damage or the absence of components, protective 

devices or housing parts. If this is the case, do not use the device!  
 

Leave maintenance and repair work to a qualified service workshop or contact your 
dealer. 

 
 

DANGER! (Electric shock due to short circuit) 

Modifications to the power cord or plug are prohibited. If the power cord is damaged, it 

must be replaced immediately with an original spare part from the manufacturer. Failure 

to do so may result in fire or death due to electric shock! 
 

 

DANGER! (For babies and children) 

Dispose of or store any packaging material properly! Packaging material must be kept out 
of the reach of babies and children due to the

 danger of suffocation

 
Make sure that children never use the device unattended! In addition, make sure that 

children do not remove (small) parts from the device, as they could suffocate by 
swallowing parts! 

 
 

Hint! (Fire hazard due to overheating) 

The maximum permissible ambient temperature of this device is 

40°C

.   

 

Ensure that the unit is placed in a place with adequate ventilation, out of the reach of 
direct heat sources, naked flames and combustible materials and liquids. 

 
The ventilation slots of the device must not be taped or covered. 

 
 

Hint! (Operating conditions) 

Due to its structural characteristics, the device is designed for indoor operation 

(IP20). 

Never expose the device to rain, moisture or liquids as this may cause damage.  
 

Vibrations, dust or solar radiation can also lead to damage, avoid them! 
 

 

Hint! (Condensation) 

To avoid condensation in the unit, the unit should adapt to the ambient temperature 
before commissioning. 

 

 
 

 
 

Summary of Contents for CM2










Reviews: