Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23
Page 13 of 41
6
Programming
Programming of alarm numbers, alarm codes and various functions can be affected by using
the keypad on the reverse of the Fältcom ECII® Flex, by calling the unit using a standard tel-
ephone or by using suitable Windows-based software. This section describes programming
using the keypad and standard telephone. All programmed settings are stored in memory
even if the lift phone is disconnected from the telephone line.
The keys on the keyboard have the following functions:
Programming
– Starts and ends all programming sequences.
Sequence receiver –
Used when programming more than 2 alarm receivers, receivers 3-6.
Alarm receiver 1 –
Phone number to alarm receiver 1.
Alarm receiver 2 –
Phone number to alarm receiver 2.
Alarm code 1 –
Used for alarm receiver 1, 3, 4, 5 and 6.
Alarm code 2 –
Used for alarm receiver 2.
The other keys have the same function as on a standard telephone.
6.1 Configuration settings
The Fältcom ECII® Flex can be programmed only after it has been set to programming mode.
The telephone line must be supplied with current for the keys to be activated. Each time the
keys are pressed in programming mode a short tone is heard and after each programming
sequence there is a 4-tone for successful and a 1-tone for unsuccessful programming.
In order for the emergency telephone to be programmed it has to be:
