Falcon Professional + FX, User Manual, Page: 25 / 38

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
23
ArtNo.010-0010 Lowering the rear rollers (90)
x10
�������������������������������������������
Fig.7-5
Fig.7-6
ArtNo.281-0138 - Drawer pulled out
Fig.7-2
ArtNo.342-0002 - Elan - drawer position
Fig.7-3
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig.7-4
Removing the Storage Drawer
Pull the drawer out to its furthest point (Fig.7-2) .
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at the
same time pull the drawer forward and away from the side
runners
(Fig.7-3) .
For safety’s sake push the drawer runners back out of the
way. Put the drawer somewhere safe - do not refit it until the
installation is complete.
Removing the Oven Door
To remove the oven door, open the door fully. Swivel the
locking ‘U’ clips forward to the locking position
(Fig.7-4) . Grip
the sides of the door, lift upwards and then slide the door
forwards
(Fig.7-5) .
When you have removed the oven door continue as follows:
First fit the levelling tool on the hexagonal adjusting nut
(Fig.7-6) .
Make 10 complete (360°) turns clockwise (Fig.7-6) . This
means turning and removing the levelling tool 20 times.
Completing the Move
Unfold the rear edge of the pack base tray. Grip the fascia
panel and lift the front of the cooker slightly.
Carefully push the cooker backwards off the pack base.
Remove the pack base. Position the cooker close to its final
position, leaving just enough space to get behind it.
DO NOT use the control knobs to manoeuvre the cooker.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the front
bottom corners of the cooker. To set the front feet turn the
bases to raise or lower. Make sure the oven door is aligned to
the cooker face.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.