*ININST.1019*
ININST.1019
Parts List
Kit.1011
Baseplate assembly for:
36” and 42” device
Kit.1013
Baseplate assembly for:
48” device
1490 EL Baseplate assembly
Left Hand Reverse
Kit.1010
Baseplate assembly for:
36” and 42” device
Kit.1012
Baseplate assembly for:
48” device
Right Hand Reverse
Notes
• Verify length and handing of new baseplate assembly matches old baseplate assembly before proceeding with disassembly.
• If the device you are replacing has been cut to a non-standard length, refer to device instruction for cut length to determine if new
retrofit baseplate assembly will fit (new baseplate may be slightly longer than old baseplate).
• If existing application, disconnect power source before working on device.
•
Consult factory if you are attempting to retrofit 1490 device that originally was not electrified.
1
Remove device from door
1a
Remove pushbar end cap on hinge
stile.
1b
Loosen two mounting screws on
channel mounting plate.
1c
Remove pushbar end cap on lock
stile.
1d
Remove two mounting screws on
lock stile and remove device from
door.
2
Remove channel from old baseplate
2a Place pushbar face down on non-
marring surface.
2b
Remove five exposed screws (one
shorter) from back of channel.
2c Slide channel from device.
Channel slides out
hinge stile of device
Shorter screw
Pushbar
Pushbar
end cap
Channel
end cap
Pushbar
end cap
Channel end cap
Channel mounting plate
Panic Exit Device Baseplate Retrofit
EL1490
Installation Instructions
(For EL1590 applications, see opposite side of instruction sheet)
