Falcon E350/40, Installation And Servicing Instructions

Page: 4 / 8

UNLESS OTHERWISE STATED, PARTS WHICH HAVE BEEN PROTECTED BY THE
MANUFACTURER ARE NOT TO BE ADJUSTED BY THE INSTALLER
1.1 MODEL NUMBER, NETT WEIGHTS and DIMENSIONS
MODEL WIDTH
mm DEPTH
mm HEIGHT
mm WEIGHT
kgs WEIGHT
lbs
E350/40 350 650 305 20 44
E350/41 700 650 305 33 73
E350/42 350 650 305 18 39
E350/43 700 650 305 30 67
All Weights are nett, exclusive of containers.
1.2 SITING
The unit should be installed on a table or similar surface. Alternatively it may be installed
upon the purpose designed floor-stand, supplied by Falcon. If it is to be positioned in close
proximity to a wall, partition etc., a clearance of 25mm at the rear and sides should be
observed. A vertical clearance of 600mm between the top of the appliance and any overlying
combustible surface must also be provided.
1.3 ELECTRICAL SUPPLY
These appliance are for use on single phase AC supplies only.
1.4 SUPPLY CONNECTION
The cable entry is located at rear of appliance and is suitable for 20mm conduit.
A suitable isolating switch with 3mm separation on both poles must be installed.
All wiring must be executed in accordance with regulations listed on cover of this manual.
This appliance must be earthed. A suitable terminal is provided for this purpose and this must be
used.
This appliance is also provided with a terminal for the connection of an external equipotential
conductor. This terminal is in effective electrical contact with all fixed exposed metal parts of the
appliance, and shall allow the connection of a conductor having a nominal cross-sectional area of up
to 10 mm². It is located on the rear panel and is identified by the following label and must only be
used for bonding purposes.
1.5 ELECTRICAL RATINGS
Electrical ratings are as stated on appliance data plate.
1.6 CONTROLS
All models are controlled by a single thermostat.
SECTION 2
– ASSEMBLY
2.1 E350/40 and E350/41 Wet Bains Marie