INSTALLATION
Check the appliance is electrically safe when you have finished.
19
LOWER THE FRONT ROLLER by doing 14 complete (360°) turns
clockwise
(Fig.6-6)
. (This means turning and removing the
levelling tool 56 times).
Now LOWER THE TWO REAR ROLLERS. First fit the levelling
tool on the hexagonal adjusting nut
(Fig.6-7)
. Make 10
complete (360º) turns clockwise
(Fig.6-8)
. (This means
turning and removing the levelling tool 20 times.)
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push the
cooker backwards out of the base pack
(Fig.6-9)
. Push the
cooker close to its final position, leaving just enough space to
get behind it.
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the
cooker.
Grip under the fascia panel and lift the front of the cooker
slightly
(Fig.6-10)
. Carefully push the cooker backwards off
the pack base. Remove the pack base tray. Position the cooker
close to its final position, leaving just enough space to get
behind it.
DO NOT use the door handles or control knobs to
manoeuvre the cooker.
Repositioning the Cooker following
Connection
If you need to move the cooker once it has been connected,
make sure it is switched off at the supply switch before
gripping under the fascia panel and lifting the front of the
cooker slightly
(Fig.6-10)
. Check behind the cooker to ensure
that the electricity cable is not caught. As you progress,
always ensure that the cable has sufficient slack to allow the
cooker to move.
If a stability chain is fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, check behind it again once
more to ensure that the electricity cable is not caught or
trapped.
Levelling
It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker, use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
ArtNo.010-0003 Lowering the rear rollers
x10
ArtNo.010-0008 Lowering the front rollers
����
Fig.6-8
Fig.6-6
ArtNo.010-0002 Rear roller nut
Fig.6-7
ArtNo.010-0004 Moving the cooker
Fig.6-10
ArtNo.010-0009 Pushing the cooker
Fig.6-9
