Falcon Classic 110 Dual Fuel, Instructions For Use And Installation, Page: 30 / 52

English
30
Conversion to Another Gas
Servicing - warning
This conversion must be performed by a competent person.
After conversion the installation must comply with the rel-
evant regulations and also the local electricity supply com-
pany requirements. Read the instructions before converting
this appliance.
Failure to convert the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
This instruction must be used in conjunction with the rest
of the appliance instruction, in particular for information on
Standards, cooker positioning, connection hose suitability
etc.
When servicing or replacing gas-carrying components dis-
connect from gas before commencing operation and check
appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Conversion
Disconnect from electricity and gas before servicing. Check
appliance is safe when you have finished.
This appliance is supplied as:-
G 20 20millibar
CAT II 2H3+
CAT II 2E3+
CAT II 2E3B/P
Check in the Technical Data section at the back of the book
that the cooker is convertible to the gas you want to use.
Injectors
Remove burner caps and heads. Remove old jets. Fit the new
jets (see
Technical Data
section at the back of the book for
correct jets). Reassemble in reverse order.
Tap Adjustment
Check in the table at the back of the book to see if the
bypass screws need to be adjusted.
Pull off all the control knobs.
Open the oven door & grill door and remove the fixing screws
underneath the control panel. Some models have a plate
under the control panel held in place by the bottom fixing
screws.
Models with a Handrail
Remove the 2 handrail end-bracket fixing screws, remove the
2 cross-headed screws that were hidden by the handrail end
brackets.
Lower fascia panel clear of top retaining tags.
Models without a Handrail
Slide the control panel to the right and then pull forward.
Take care not to damage or strain the wiring.
To Convert to Other Gases
Turn the bypass screw on each control clockwise until it stops.
ArtNo.0102-0011 - Screwing
the control valve bypass screw
See table at the back of this book for correct size.
Refit the control panel.
Stick on Label
Stick the appropriate label on to the data badge to indicate
the gas the appliance is now set for.
Pressure Testing
Connect the appliance to the gas supply. Check the appliance
is gas sound.
See ‘
Technical Data’ section at the back of this book for test
pressures.
The gas pressure can be measured at one of the left hand
hotplate burner jets. Lift off a burner head. Fit the pressure
gauge to the jet. Turn on the hotplate burner and turn on and
light one of the other burners.
Reassemble burner top, making sure it is reassembled in the
correct way on the burner body.
Check the appliance is gas sound.
Check operation of all the burners.