Blue sealant appears on top of the cartridge
URINAL BOWL
CLEANING INSTRUCTIONS
C1M2+ CARTRIDGE
CHANGING INSTRUCTIONS
WHEN SHOULD A CARTRIDGE BE CHANGED?
Spray (mist) cleaner on the entire bowl.
Clean outside and inside of bowl with rag, sponge, or mop.
1
2
OR
Fluid does not drain into the cartridge
OR
OR
MAINTENANCE
CAUTION
After removing cartridge
from housing, certain naturally
occurring but
potentially hazardous
sewer gases
may escape through the
opening until re-installed properly. If
replacement cartridge will not be re-
installed immediately, place a rag or
paper towels into opening to block any sewer gases. Remove
the paper towels or rag prior to inserting new cartridge.
Alternatively, use Falcon Foam Housing Cleaner to both clean
housing during cartridge change.
Never smoke, have an
urinal housings into which a cartridge is not yet properly
installed.
You also can wear a breathing mask when removing or
installing any waterless urinal or cartridge to reduce potential
exposure to any such gases.
SEA
LA
NT
Wat
erf
ree
Urin
al Se
ala
nt
Insert key into cartridge.
Scrub the housing and deep inside of the tailpipe
with a long 1.5-inch diameter nylon brush.
Insert new cartridge into housing and
turn key to right to lock and click into
place.
Turn key to left to unlock.
Flush housing with 5
gallons (20 liters) of hot
soapy water.
liter) or more of clean water until
there are no air bubbles.
Lift and tilt cartridge to drain all free liquids then
spray Falcon Foam Housing Cleaner into housing.
Wipe clean inner stainless
steel rim.
Add blue sealant (allow time to drain
into cartridge).
Place cartridge into bag, tie
bag to seal and dispose.
Spray (mist) bowl with cleaner and
wipe clean.
1
2
5
H3
H1
7
3
4
8
9
10
11
6
2255 Barry Ave. Los Angeles, CA 90064 | Tel 310.209.7250 |
FalconWaterfree.com
