2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Kawasaki Teryx 4
Aero-Vent Lexan Windshield
KAW-TERYX4-WD05
NOTICE: Please check contents of package for any damage and make sure all parts fit
correctly and you are happy with the product before removing protective film. Once the
film is removed you cannot return the product for a full refund.
1.
Be sure to read these instructions thoroughly before opening and installing the Kawasaki
Teryx 4 Aero-Vent Lexan Windshield.
2.
Check over the parts included in the cartons with the parts list shown below:
17/8” Loom Clamps
6 each
1” Stainless Steels Bolts
12 each
Stainless Steel Washers
16 each
Plastic Thumb Nuts
8 each
Lock Nuts
4 each
Slide Fasteners
8 each
Rubber Gasket
1 each
Lexan Brace
1 each
Lexan Vent Sliders
2 each
Lexan Windshield
1 each
3.
Before beginning installation, please test fit the windshield on your vehicle. Once
the protective film is removed you can no longer return for a refund.
4.
Start by pulling it out of the box and find a clean area to lay it down and install the
hardware. Begin by peeling off the protective film. Next take the piece of rubber gasket
and starting at one end firmly place across the bottom of the windshield. You may need
to trim off excess gasket. The diagram below show where to install the gasket.
