2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Husqvarna 4400
Aero-Vent Lexan Windshield
HU-4400-WD05
PLEASE NOTE: Test fit your windshield on your vehicle prior to removing protective film to ensure
proper fitment. Once protective film is removed it cannot be returned for a refund.
Be sure to read these instructions thoroughly before opening and installing the 09” Polaris Ranger Lexan
Windshield.
1.
Check over the parts included in the cartons with the parts list shown below:
2” Loom Clamps
10 each
1” Stainless Steels Bolts
15 each
Stainless Steel Washers
19 each
Slide Fasteners
4 each
Lock Nuts
4 each
Plastic Thumb Nuts
11 each
Sliding Vent Panels
1 each
45" End Bulb Gasket
1 each
49" End Bulb Gasket
1 each
Bent Lexan Braces
1 each
Lexan Windshield
2 Pieces
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2.
Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Next take
the rubber gasket and starting at one end firmly place along entire bottom and top edges of the lower
Windshield Section. You will need to peel back the protective film from the edge to install the gasket.
If you leave the bulk of the protective film on while installing you can keep from scratching the
windshield. Image for representation purposes only. Not of this machine.
3.
Next Install the Aero-Vent sliders as shown in the diagram below.
