1 0
ZWP 10
1
2
!
1
x2
2 3
t<1s
I N / E X
2 3
1
4
x1
x2
x 1
t<1s
I N / E X
2 3
1
4
Removing device from the controller - EXCLUDE
Press twice IN/EX button within 1 sec. LED's 2
and 3 will light up.
Within 1 0 sec. press P button on the device and
hold until the network status LED lights up (see
device programming manual).
- Controller signals device correct removing
from the network and group by lighting of LEDs 1
and 4.
- Controller signals incorrect removing by
blinking of LEDs 2 and 3 and the procedure
should be performed again from point 1 .
Note! With the use of EXCLUDE function it is
also possible to remove (reset) devices assigned
to other networks.
If the user wants to completely remove device from
the Z-Wave network (reset HomeID) e.g. in order to
assign to another controller, below presented procedure
must be performed. But one should bear in mind that
this procedure will remove device from buttons of
movement and controller's memory.
Controller programming – basic functions
Resetting the controller will cause removing of all
devices from its memory and the change of unique
HomeID network address for a new one.
Removing devices from the controller will not cause
reset of devices themselves. If the user wants to add
them once again to the Z-Wave network (controller's
memory) it is necessary to perform EXCLUDE
procedure on devices and assign them again.
Restoring controller to factory settings - DEFAULT
Within 1 sec. press twice IN/EX button and once
SELECT button until LEDs 2,3-1 ,4-2,3 blink.
- If a given sequence of LEDs does not occur it is
necessary to perform procedure again.
DEFAULT function will set the SECONDARY
controler again as the PRIMARY controller.
All manuals and user guides at all-guides.com
