3.2. Associating device with a pair of buttons on the controller (ASSOCIATE function)
Associating the device with a pair on buttons on the controller, which has been already included in
the Z-Wave network according to section 2.1, makes it possible to operate the device. This procedure can be
carried out on the primary and secondary controllers. The procedure of associating the device with buttons is
presented in
Figure 3
*) Programming error can be caused by:
•
no button being pressed within 10 seconds from the controller signaling its readiness for associating a
new device with the network;
•
long distance between the controller and device being added;
•
device already belongs to another network or it has not been associated with any network. It is necessary
to perform EXCLUDE function on the device and repeat INCLUDE and ASSOCIATE functions.
11.09.21 NC826
6/16
©2011,
FAKRO
Figure 3: Device associating with selected pair of buttons on controller
2
. The controller is signilizing
readiness for associating the
device with a pair of buttons on
the controller (buttons light up for
10 sec. as presented in the
drawing).
4
. The controller is signalizing that the
device has been successfully associated
(button light up for 2-3 sec. as
presented in the drawing).
5*
. Programming error – buttons
flashing for 2-3 sec. as presented in
the drawing.
1
. Within 1 sec. press:
- “
In/Ex
” (
1
) button once and then
- the button from this pair pf buttons
which will operate the device (e.g.
2
).
3. Press “P” button on the device and
hold it for 0.5 sec. (see Device
Programming Manual).
x1
1
x1
2
x1
Summary of Contents for ZWG3
Page 13: ...11 09 21 NC826 13 16 2011 FAKRO ...
Page 14: ...11 09 21 NC826 14 16 2011 FAKRO ...
