20
GENERAL
GB
3.Assemblying
When assembling your steam mop there may be a little water in
or around the water tank. This is because we test all our steam
mops 100% before you buy them, so you get a quality Fakir
Steam Expert.
1. Assemble the handle with telescopic pipe and fix them with the
screw (middle one: 4x28mm). Assemle the telescopic pipe with
the body and fix them with the screw (biggest one: 6x40mm).
Lastly, assemble the mop head with the body and fix them with
the screw (smallest one: 4x6mm).
2. Select the mop you want to use and then place it to the mop
heads’ base.
3. Remove the water tank by lifting it slightly upwards and fill with
water until its maximum level then put the water bank back to its
place. Do not fill water tank with the excess water.
DIRT CAN NOT HIDE ON EITHER SIDE!
All new design allows
for optimal cleaning!
4. For your comfort, you can adjust the height of the mop. Just lift
the latch on the tube 90 degrees to the open position. Holding
the handle, extend the tube to the height that’s right for you and
then close latch to locked position.
5. Plug in mop, press the on-off button then wait 1 min. or less for
the mop to heat up. Steam is created automatically.
