Page
Chapter: 6
Section:
2
PROGRAM EXECUTION
OPERATION
6.2 OPERATION
Follow these steps in order to access this operating mode:
*
Press the
key and select the “PROGRAMMING” option.
*
Select the “EXECUTE PROGRAM” option.
The DRO will display the positions of the selected axes and will request the number
of the program to be executed. It will do this by opening a window at the bottom of the
screen.
After indicating the program number and pressing
, the DRO will start
executing the program from the first block.
Each bLock must be executed as follows:
1.-
The DRO will show, at the bottom of the screen, the number of the block being
executed.
2.-
If a new tool is selected in the block in execution, the DRO will display the number
of the new tool in the lower right-hand side window “TOOL”.
After changing the tool, press the NEXT softkey.
3.-
The DRO will display the current position with respect to the point programmed in the
block. i.e. the distance to travel to reach that point.
4.-
Position the tool at the programmed point by moving the axes until the axes displays
read 0.
5.-
Perform the operations corresponding to that point and press the NEXT softkey.
The DRO will consider this block finished and it will display the next block.
Repeat all these steps for each block of the program. When the execution of the program
is ended, the DRO will show the corresponding message at the bottom of the screen.
Press any key to clear that message and press the EXIT softkey to quit the program
execution mode. The DRO will show the “PROGRAMMING” menu.
Press the EXIT softkey to quit the program execution mode any time during the execution
of a program.
Summary of Contents for VNP400
Page 1: ...FAGOR VNP400 Ref 9506 in...
